Save Money by Shorter Warm Up

Automotiverz - With technological developments, starting the engine in cold conditions became easier. No more choke because mechanisms such as “choke” do not exist anymore. Choke only exist on old engines or old cars. Also do not need to put a feet on the accelerator when going to start the engine.


Sit behind the wheel. Rotate the ignition key to "start" position (or press the button). Normal machines should immediately start running.


If it is turned on from cold conditions -in the morning- rpm above 1000 rpm and for smaller machines, such as 1300 cc, between 1100 and 1200 rpm. After that, a few tens of seconds later, down by itself into normal stationary conditions (slow), below 1000 rpm.

There are still heating time for the machine, but it became shorter. Maximum one minute long. After that, the vehicle could run. Even if the round has not been returned to a stationary position, the car can run.

Injection. That's the greatness of today's machines. Fuel needs are no longer being sucked, but injected. Heating time and engine speed is controlled by computer that receives the information from many sensors.


Computer controls the machine work. If the engine temperature is not too cold, no need to warm it up for long. In this way, besides making fuel consumption more efficient on the machine also reduces environmental pollution.

In the current technology of fuel injection, direct gasoline is sprayed into the combustion chamber. That makes warming up faster!

Oil factor. Oil also determines the needed time to warming up the machine. Good quality oil with low viscosity, for example already in the energy conserving category, makes the engine easier to start, because the resistance from the oil is lower.


However, if the oil is thick with high viscosity, of course, needed greater power to resist it. This also affects the time needed to warming up the machine.

So, in the morning, do not let the engine stationary in a long time. Also, do not press the accelerator to speed up the engine. That the same as throwing money and participating in the environment pollution.

Read the manual if you have doubts. Take advantage of the latest technology!